GMC chervolet camaro 1999 Service Manual page 548

Brakes
8. Inspect the brake caliper mounting bracket guide
surfaces for corrosion and wear. Remove and
replace the brake caliper mounting bracket
if necessary.
9.
Clean all the residue from the brake pad guiding
surfaces on the brake caliper housing and the
brake caliper mounting bracket.
10.
Clean all the parts not included in the repair kit
with denatured alcohol.
11 . Dry all the parts with filtered unlubricated
compressed air.
12. Blow out all passages in the brake caliper housing
and the brake caliper bleeder valve.
Assembly Procedure
Notice: Refer to Fastener Notice in Cautions and
Notices.
1. Install the brake caliper bleed screw.
Tighten
Tighten the brake caliper bleed screw to
12 N-m (106 lb in).
2. Install the brake caliper bleed screw cap.
3. Lubricate the new piston seals and the brake
caliper bore seal grooves with brake fluid.
4. Install new seals into the brake caliper bore seal
grooves.
5. Make sure the seals are not twisted.
6. Lubricate the brake caliper bores· and the pistons
with brake fluid.
7. Install the boot and piston.
7.1. Install the boot over the end of the piston
so that the fold will face toward the brake
caliper housing piston bore opening.
7.2. Seat the boot into the brake caliper bore
groove and slide the piston into the brake
caliper bore.
7.3. Push down the piston to the bottom of the
brake caliper bore.
Disc Brakes 5-73
171985
373242
373241