GMC chervolet camaro 1999 Service Manual page 524

Brakes
Notice:
Refer to Fastener Notice in Cautions and
Notices.
', 3. Install the brake pedal nuts (3) attaching the
brake booster to the brake pedal with bracket (6).
Tighten
Tighten the brake pedal nuts to 20 N·m (15 lb ft)
in the following sequence:
3.1. Inboard upper
3.2. Outboard lower
3.3. Outboard upper
3.4. Inboard lower
4. On manual transmission equipped vehicles only,
install the clutch master cylinder nuts
(7).
Tighten
Tighten the clutch master cylinder nuts to
27 N·m (20 lb ft).
5. Install the master cylinder (6) onto the brake
booster (1).
6. Install the master cylinder nuts (7) attaching the
master cylinder to the brake booster.
Tighten
Tighten the brake master cylinder nuts to
29 N·m (21 lb ft)
7. Connect the vacuum hose (8) and the clamp (9)
to the check valve (10).
8. Install the left side instrument insulator. Refer to
Insulator Replacement - IP {Left Side) in
Instrument Panel, Gauges and Console.
9. Install the left side air inlet screen. Refer to Air
Inlet Grille Panel Replacement in Body front End.
10.
lnstal the left and right side wiper arms. Refer to
Wiper Arm Replacement in Wiper Washer
Systems.
11. Install the hood rear seal. Refer to Seal
Replacement - Hood Rear in Body Front End.
12. Bleed the brakes. Refer to Hydraulic Brake
System Bleeding (Manual Bleed) or Hydraulic
Brake System Bleeding (Pressure Bleed).
Hydraulic Brakes 5-49
1
2
6
5
4
184981 '