Power Steering Pump Front Bracket; Replacement (5.7 L Vin G) - GMC chervolet camaro 1999 Service Manual

2-22 Power Steering System
391535
290570
Steering
Assembly Procedure
1. Install the flow control spring (2) to the hydraulic
pump housing assembly (1).
2. Install the control valve assembly (3).
3. Lubricate the 0-ring seal (4) with power
steering fluid.
4. Install the 0-ring seal (4) on to the 0-ring
union fitting (5).
Notice:
Refer to Fastener Notice in Cautions
and Notices.
5. Install the 0-ring union fitting (5) into the hydraulic
pump housing assembly
(1 ).
Tighten
Tighten the 0-ring union fitting (5) to
75 N·m (55 lb ft).
Power Steering Pump Front Bracket
Replacement (5.7 L VIN G)
Removal Procedure
1. Place drain pan under pump (1).
2. Remove air intake resonator and mass airflow
sensor assembly.
3. Remove the serpentine belt. (
4. Remove the power steering pump pulley from
ttie pump. Refer to Power Steering Pulley
Replacement in Power Steering.
5. Support pump assembly with twine or rope.
Important: The front power steering pump bracket
can be removed without the complete disconnection
of the pump. The hydraulic hoses do not need to
be disconnected.
6. Remove power steering pump attaching bolts (4)
and front power steering pump bracket (3).
(