Pivot And Pulse Switch Assembly - Disassemble - Off Vehicle - GMC chervolet camaro 1999 Service Manual

Steering
8. Tighten the hexagon washer head screw (1).
Tighten
Tighten the hexagon wast)_er head screw
to 2.5 N-m (22 lb in).
9. Tighten the washer head screw (2).
Tighten
Tighten the washer head screw to 4 N-m (35 lb in).
10. Insert the vehicle wire harness into the dimmer
switch assembly (3).
11. Remove the steering column and J 41352
from the vise.
12. Remove J 42640 from the column.
Pivot and Pulse Switch Assembly -
Disassemble - Off Vehicle
Disassembly Procedure
1. Remove the lock housing cover and sleeve
assembly. Refer to Lock Housing Assembly·
Disassemble.
2. Remove the switch actuator pivot pin (2) from the
pivot and pulse switch assembly (1).
3. If removal of the pivot and pulse switch
assembly (1) is not needed let the pivot and pulse
switch assembly (1) hang freely. ·
4. Remove the pivot and pulse switch assembly (1)
from the lock housing cover and sleeve assembly
following these steps: · ·
4.1. Remove the wire protector shield.
4.2. Remove the pivot and pulse switch
assembly connector from the bulk
head connector.
4.3. Pull the wire harness through the
steering column.
Important: Use care not to damage the wires when
pulling the pivot and pulse switch assembly wire
harness through the steering column.
Steering Wheel and Column - Tilt 2-89
393978
343835