Park Brake Cable Replacement (Front) - GMC chervolet camaro 1999 Service Manual

Brakes
12. Rotate the adjuster arm toward the rear of the
vehicle and completely raise the park brake
lever (1 ).
13. Install the park brake adjuster spring (2).
14. Cycle the park brake lever 3 times.
15. Install the front floor console. Refer to Console
Replacement - Front Floor in Instrument Panel,
Gauges and Console.
Park Brake Cable Replacement (Front)
Removal Procedure
Tool Required
J 37043 Parking Brake Cable Release Tool
Notice: Use care when performing service operations
on or around parking brake cables. Damage to the
plastic coating will reduce corrosion protection and if
the damaged area passes through the seal,
increased parking brake effort could result. Contacting
the coating with sharp-edged tools, or with sharp
surfaces of the vehicle underbody, should be avoided.
1 . Ensure that the park brake hand lever is in the
down position in order to disengage the
adjuster pawl.
2. Raise and suitably support the vehicle. Refer to
Lifting and Jacking the Vehicle in General
Information.
3. Pull down on the front cable strand until the
strand stops and stays extended.
4. Remove the rear cables (2) from the equalizer (3).
5. Use the J
37043 in order to remove the fitting of
the park brake front cable from the bracket.
Park Brake 5-89
182184
182210
214860