GMC chervolet camaro 1999 Service Manual page 551

5-76 Disc Brakes
171977
171983
Brakes
Assembly Procedure
Notice: Refer to Fastener Notice in Cautions and
Notices. (
1. Install the brake caliper bleed screw.
Tighten
Tighten the brake caliper bleed screw to
12 N·m (106 lb in).
2. Install the brake caliper bleed screw cap.
1. Lubricate the new piston seal and the brake
caliper bore seal groove with brake fluid.
2. Install the new seal into the brake caliper bore
seal groove.
3. Make sure the seal is not twisted.
4. Lubricate the brake caliper bore and the piston
with brake fluid.
5.
Install the boot and piston.
5.1.
Install the boot over the end of the piston (
so that the fold will face toward the brake
caliper housing piston bore opening.
5.2.
Seat the boot into the brake caliper bore
groove and slide the piston into the brake
caliper pare.
5.3. Push down the piston to the bottom of the
brake caliper bore.
5.4. Make sure the boot is properly seated into
the piston groove and into the groove in the
brake caliper bore.
5.5. Repeat Steps 5 and 6 for the remaining
piston.
6. Install the brake caliper to the vehicle. Refer to
Brake Caliper Replacement (Rear).
(