Steering
Inflatable Restraint Steering Wheel
Module Coil - Disassemble - Off Vehicle
Disassembly Procedure
Tools Required
• J
41352 Modular Column Holding Fixture
• J 42640 Steering Column Anti Rotation Pin
1. Set th~ steering column and J 41352 into a vise.
Important:
The column must be in the center position.
Remove only those components necessary to do
the repairs.
Check the steering column jacket assembly for
accident damage. Refer to Steering Column Accident
Damage - Off Vehicle.
2. Install J 42640 into the lower shroud.
3. Place the ignition in the "LOCK" position to center
the coil assembly.
4. Remove the wire harness assembly strap (1).
5. Remove the retaining ring from the steering
shaft assembly.
6. Remove the wire harness straps and the wire
protector from the steering column.
7. Disconnect the SIR coil assembly connector at
the base of the steering column, if needed.
8. Remove the SIR coil assembly from the steering
shaft assembly.
9. Attach mechanics wire to the SIR coil assembly
connectors for reassembly.
10. Pull the SIR coil assembly connectors through the
steering column, if needed.
Steering Wheel and Column - Tilt 2-77
343711
343702
343717