Master Cylinder Reservoir Replacement - GMC chervolet camaro 1999 Service Manual

5'."24 Hydraulic Brakes
5
182445
1
3
4
6
5
182445
Brakes
Master Cylinder Reservoir Replacement
Removal Procedure
1. Remove the master cylinder (5). Refer to Master
Cylinder Replacement
Notice:
Do not overtighten vise, or damage to the
master cylinder will result.
2. Clamp the flange on the master cylinder body in
a vise.
3. Drive out the master cylinder reservoir pins (6).
Use a 1/8-inch punch.
4. Remove the master cylinder reservoir (3) by
pulling the reservoir straight up and away from
the cylinder body.
5. Remove the master cylinder reservoir
grommets (4 and 7) from the grooves in the
reservoir. Discard the grommets.
6. Inspect the reservoir for cracks or deformation.
Replace the reservoir if necessary.
7. Use clean denatured alcohol to clean the
reservoir.
8. Use non-lubricated compressed air to dry the
reservoir.
Installation Procedure
1. Use clean brake fluid to lubricate the new
grommets (4 and 7) and the grooves in the
reservoir.
2. Insert the grommets into the grooves in the
reservoir. Verify that the grommets are properly
seated.
3. Connect the reservoir (3) to the master cylinder
body (5). Use your hand in order to press the
reservoir straight down into the cylinder body.
4. Drive in the master cylinder reservoir pins (6) in
order to retain the reservoir.
5. Install the master cylinder. Refer to
Master
Cylinder Replacement
(
(