GMC chervolet camaro 1999 Service Manual page 20

General Information
Camaro/Firebird RPO Table (cont'd)
RPO
Description
520 Trim Combination, Cloth Light Neutral
521 Interior Trim, Medium Neutral
522
Trim Combination,
Leather Light Neutral
523
Trim Combination,
Leather Medium Neutral II
524
Trim Combination,
Leather Medium Neutral
56T Top Color, Medium Dark Neutral
630 Molding Color, Sport Gold
63U Exterior Color, Sport Gold
738 Trim Combination, Cloth Flame Red
731 Interior Trim, Flame Red
790 Molding Color, Mystic Teal
79U Primary Color, Exterior Mystic Teal
810
Molding Color, Bright Red
81U Primary Color, Exterior Bright Red
880
Molding Color, Bright Purple
88U Primary Color, Exterior Bright Purple
928
Trim Combination,
Cloth Medium Pewter
921 Interior Trim, Pewter
960 Molding Color, Cayenne Red
96U
Primary Color, Exterior Cayenne Red
Metallic
990 Molding Color, Hugger Orange
99U Exterior Color, Hugger Orange
General Information 0-17
Labels - How to Obtain Replacement
Obtain replacements for the following labels through
the GM Service Parts Operations:
• The vehicle emission control information (exhaust
emission tune-up) label
• The spare wheel caution label
• The jacking label
• The serpentine belt routing label
• The engine fan caution label
• The spare tire storage label
The following labels are not available as service parts:
• The vehicle certification label
• The tire pressure placard
• The service parts identification label
Fasteners
Metric Fasteners
This vehicle is dimensioned in the metric system. Most
metric fasteners are very close in diameter to well
known fasteners in the English (inch) system. Replace
fasteners with those of the same nominal diameter,
thread pitch, and strength.
A number marking identifies the OE metric fasteners
(except cross-recess head screws). The number
also indicates the strength of the fastener material.
A
Posidriv® or Type 1 A cross-recess identifies a
metric cross-recess screw. For best results, use a
Type 1A cross-recess screwdriver, or equivalent, in
Posidriv® recess head screws.
GM Engineering Standards and North American
Industries have adopted a portion of the ISO-defined
standard metric fastener sizes. The purpose of
this was to reduce the number of fastener sizes used
while retaining the best thread qualities in each
thread size. For example, the metric M6.0 X 1 screw,
with nearly the same diameter and 25.4 threads
per inch replaced the English 1/4-20 and 1/4-28
screws. The thread pitch is midway between the
English coarse and fine thread pitches.