GMC chervolet camaro 1999 Service Manual page 298

Steering
Installation Procedure
1. Install the automatic park lock cable, if equipped.
2. Complete the following steps in order to
ensure that the ignition switch (2) is in the
LOCK (1) position:
2.1. Move the switch slider to the extreme
right position.
2.2. Move the slider one detent to the left.
3. Ensure that the following components are in the
LOCK position:
• The steering column lock
• The ignition cylinder
4. Install the ignition switch (7) to the jacket (1 ).
5. Install the ignition switch actuator rod (3) to the
ignition switch.
Notice: Refer to Fastener Notice in Cautions
and Notices.
6. Install the bolt/screw (6).
Tighten
Tighten the bolt/screw (6) to 2.5 N-m (22 lb in).
7. Position the dimmer switch (5) to the ignition
switch (7).
8. Install the bolts/screws.
9. Complete the following procedures in order to
adjust the dimmer switch:
9.1. Press the switch mechanism slightly in
order to insert the 3/32-inch drill bit.
9.2. Move the dimmer switch in order to
remove the lash.
Tighten
Tighten the bolts/screws to 4 N·m (35 lb in).
10. Install the electrical connectors to the dimmer
switch (5) and the ignition switch (7).
11. Install and adjust the parking brake switches.
12. Raise the column.
13. Install the steering column upper support nuts to
the steering column support. Refer to Steering
Column Replacement.
14. Install the steering column dash cover bolts.
15. Enable the SIR. Refer to Enabling the SIR System
in Supplemental Inflatable Restraint System.
16. Install the instrument panel driver knee bolster
and deflector. Refer to Knee Bolster Replacement
in Instrument Panel, gages and Console.
17. Install the left-hand instrument panel insulator.
Refer to Insulator Replacement - IP (Left Side)
in Instrument Panel, Gages and Console.
Steering Wheel and Column - Tilt 2-67
1
290208
290273