Steering
Installation Procedure - 3800 VIN K
\
1. Install outlet hose to reservoir ( LS1 with cooler
I
shown, remote-mount reservoir on L36).
)
(Pump mounted on LS1, body mounted on L36)
Important:
Inlet and outlet hoses must be oriented so
as adequate clearance is maintained between both
hoses and surrounding components to prevent chafing.
Use minimum clearance of 12 mm (.47 inch). The
outlet hose must not
be
twisted during installation. Do
not bend or distort inlet and outlet hoses to make
installation easier. Failure to follow these procedures
could result in component damage.
2. Install inlet hose fitting (3) to
pump (1) (L36 shown, LS1 similar).
Power Steering System 2-35
354416
354420