Steering
5. Seat the counterbore of J 39246 over the steering
shaft assembly (1 ).
6. Thread and seat the standard hexagon nut (2)
onto the steering shaft assembly (1 ).
7. Thread the hexagon nut (2) until it contacts the
block of J 39246.
8. Insert the square end (2) of J 39246 into the
spring retainer (1) and seat.
9. Rotate the tool bolt clockwise with a wrench until
it contacts the surface of the tool block.
10. Make a
V4
turn counter clockwise to the hexagon
section on the end of the tool bolt.
11. Unscrew the tool bolt until the wheel tilt spring
and the spring retainer (1) are free.
12. Remove J 39246.
13. Install the lock housing cover and sleeve assembly.
Refer to
Lock Housing Assembly - Assemble.
Steering Wheel and Column - Tilt 2-93
1
343839
343842
343845