Disassembling Front Axle [4Wd Type] - Kubota M6800S Workshop Manual

M6800 · M6800S · M8200 · M9000, WSM

(4) Disassembling Front Axle [4WD Type]

Steering Cylinder
1. Remove the cylinder cover.
2. Disconnect the power steering hoses (3).
3. Remove the cylinder clamps (1).
4. Take out the steering cylinder (2).
(When reassembling)
Steering cylinder mounting
nut
Steering cylinder mounting
Tightening torque
lock nut
Cylinder cover mounting
screw
(1) Cylinder Clamp
(2) Steering Cylinder
Tie-rod
1. Pull out the cotter pin and remove the tie-rod end slotted nuts.
2. Remove the tie-rod with a tie-rod end lifter (Code No. 07909-
39051).
(When reassembling)
• Replace cotter pin with a new one.
• Bend the cotter pin as shown in the figure.
Tie-rod end slotted nut
Tie-rod joint lock nut
Tightening torque
Knuckle arm mounting
screw (M12)
Knuckle arm mounting
screw (M14)
Separation of Front Differential Case and Bevel Gear Case
1. Remove the bevel gear case (2) and the front wheel case (3) as
a unit from the front differential case (1).
(When reassembling)
• Apply grease to the O-ring.
• Install the bevel gear case to the front differential case, noting the
O-ring.
Bevel gear case mounting
screw (M12, UBS screw
9T)
Tightening torque
Bevel gear case mounting
screw M14, 7T
(1) Front Differential Case
(2) Bevel Gear Case
6-S12
FRONT AXLE
34.3 to 39.2 N·m
3.5 to 4.0 kgf·m
25.3 to 28.9 ft-lbs
39.2 to 45.1 N·m
4.0 to 4.6 kgf·m
28.9 to 33.3 ft-lbs
48.1 to 55.9 N·m
4.9 to 5.7 kgf·m
35.4 to 41.2 ft-lbs
(3) Power Steering Hose
W1014942
156.9 to 176.5 N·m
16.0 to 18.0 kgf·m
115.7 to 130.2 ft-lbs
166.7 to 196.1 N·m
17.0 to 20.0 kgf·m
123.0 to 144.7 ft-lbs
77.5 to 90.2 N·m
7.9 to 9.2 kgf·m
57.1 to 66.5 ft-lbs
123.6 to 147.1 N·m
12.6 to 15.0 kgf·m
91.1 to 108.5 ft-lbs
W1015246
127.5 to 142.2 N·m
13.0 to 14.5 kgf·m
94.0 to 104.9 ft-lbs
123.6 to 147.1 N·m
12.6 to 15.0 kgf·m
91.1 to 108.5 ft-lbs
(3) Front Wheel Case
W1015400
KiSC issued 03, 2008 A