Fuel Level Gauge Inspection; Speedometer Inspection; Speed Sensor Removal And Installation - Suzuki 2005 GSF1200 Service Manual

9C-5 Combination Meter / Fuel Meter / Horn:
7) Replace the 180 Ω resister "B" with a 5 Ω one "C".
8) The fuel level indicator is operating correctly if the
LCD bars increase to five (full) when the ignition
switch is turned to ON.
If either test detects a malfunctioning fuel level
indicator, replace the combination meter unit with a
new one.
"C"
1
1. Fuel gauge wire coupler

Fuel Level Gauge Inspection

Inspect the fuel level gauge in the following procedures:
1) Remove the fuel level gauge. Refer to "Fuel Level
Gauge Removal and Installation: in Section 1G".
2) Measure the resistance at each fuel level gauge float
position. If the resistance is incorrect, replace fuel
level gauge with a new one.
Special tool
: 09900–25008 (Multi-circuit tester set)
Tester knob indication
Resistance (Ω)
Float position
"A" (Full)
"B" (Empty)
"A"
82.3
"B"
3) Install the fuel level gauge. Refer to "Fuel Level
Gauge Removal and Installation: in Section 1G".
I649G1930012-01
B649G19306017
Resistance
3 – 5 Ω
179 – 185 Ω
13.2
I649G1930013-02

Speedometer Inspection

If the speedometer, odometer or tripmeter does not
function properly, inspect the speed sensor and the
coupler connections. If the speed sensor and coupler
connections are OK, replace the combination meter unit
with a new one. Refer to "Combination Meter Removal
and Installation: ".

Speed Sensor Removal and Installation

Removal
1) Remove the seat. Refer to "Exterior Parts Removal
and Installation: in Section 9D".
2) Disconnect the speed sensor coupler (1) and clamp.
3) Remove the speed sensor (2).
2
Installation
Install the speed sensor in the reverse order of removal.
Pay attention to the following point:
• Route the speed sensor lead wire. Refer to "Wiring
Harness Routing Diagram: in Section 9A".
B649G19306018
B649G19306019
1
I649G1930014-01
I649G1930015-01