Rear Brake Caliper Removal And Installation - Suzuki 2005 GSF1200 Service Manual

Table of Contents

Advertisement

7) Install the new brake pads.
NOTE
Make sure that the detent of the pad is seated
onto the retainer on the caliper bracket.
8) Tighten the caliper mounting bolt (7) and pad
mounting pin (8) to the specified torque.
Tightening torque
Rear brake caliper mounting bolt (a): 22 N·m (
2.2 kgf-m, 16.0 lb-ft)
Rear brake pad mounting pin (b): 18 N·m (1.8
kgf-m, 13.0 lb-ft)
8,
(b)
7,
(a)
9) Install the plug (9) to the specified torque.
Tightening torque
Pad pin plug (c): 2.5 N·m (0.25 kgf-m, 1.8 lb-ft)
NOTE
After replacing the brake pads, pump the
brake pedal few times to check for proper
brake operation and then check the brake
fluid level.
I649G1430006-01

Rear Brake Caliper Removal and Installation

Removal
1) Drain brake fluid. Refer to "Brake Fluid
Replacement: in Section 4A".
2) Remove the brake hose from the caliper by
removing the union bolt (1) and catch the brake fluid
in a suitable receptacle.
NOTE
Place a rag underneath the union bolt on the
brake caliper to catch any spilt brake fluid.
I649G1430007-03
3) Remove the brake pads. Refer to "Rear Brake Pad
Replacement: ".
NOTE
Slightly loosen the sliding pin (2) to facilitate
later disassembly, if necessary.
Rear Brakes:
9,
(c)
1
2
4C-3
I649G1430008-03
B649G14306014
I649G1430009-01

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

2005 gsf1200s1200 banditGsf1200Gsf1200s

Table of Contents