Suzuki 2005 GSF1200 Service Manual page 350

5B-12 Manual Transmission:
Oil Seal Retainer
• Install the oil seal retainer (1) with the four bolts and
then bend up the tabs on the retainer.
NOTE
Route the gear position switch lead wire to
the inside of the oil seal retainer's tab "A" as
shown.
1
"A"
• Install the starter clutch component parts. Refer to
"Starter Clutch Removal and Installation: in Section
1I".
• Install the gearshift shaft and gearshift driven gear.
Refer to "Gearshift Shaft / Gearshift Cam Driven Gear
Removal and Installation: ".
• Install the clutch component parts. Refer to "Clutch
Installation: in Section 5C".
• Install the CKP sensor component parts and connect
the oil pressure switch lead wire. Refer to "CKP
Sensor Removal and Installation: in Section 1H" and
"Oil Pressure Switch Removal and Installation: in
Section 1E".
• Install the cam chain tensioner. Refer to "Engine
Bottom Side Assembly: in Section 1D".
CAUTION
!
Be sure to check the camshaft position.
• Install a new oil filter. Refer to "Engine Oil and Filter
Replacement: in Section 0B".
• Install the starter motor. Refer to "Starter Motor
Removal and Installation: in Section 1I".
I649G1520040-01 • Install the generator. Refer to "Generator Removal
and Installation: in Section 1J".
• Remount the engine assembly. Refer to "Engine
Assembly Installation: in Section 1D".