Suzuki 2005 GSF1200 Service Manual page 35

Engine Oil and Filter Replacement
Replace engine oil
Initially at 1 000 km (600 miles, 2 month) and every 6
000 km (4 000 miles, 12 months) thereafter.
Replace oil filter
Initially at 1 000 km (600 miles, 2 month) and every
18 000 km (11 000 miles, 36 months) thereafter.
Oil should be changed while the engine is warm. Oil filter
replacement at the above intervals, should be done
together with the engine oil change.
Engine Oil Replacement
1) Keep the motorcycle upright.
2) Place an oil pan below the engine, and drain engine
oil by removing the oil drain plug (1) and filler cap
(2).
1
2
3) Tighten the oil drain plug (1) to the specified torque,
B649G10206007
and pour new oil through the oil filler. When
performing an oil change (without oil filter
replacement), the engine will hold about 3.3 L of oil.
Use of SF/SG or SH/SJ in API with MA in JASO.
Tightening torque
Oil drain plug (a): 23 N·m (2.3 kgf-m, 16.5 lb-ft)
4) Start up the engine and allow it to run for several
minutes at idling speed.
5) Turn off the engine and wait about three minutes,
then check the oil level through the inspection
window (3). If the level is below the "L" mark, add oil
to the "F" mark. If the level is above the "F" mark,
drain the oil until the level reaches the "F" mark.
I649G1020019-01
Oil Filter Replacement
1) Drain engine oil as described in the engine oil
I649G1020020-01 replacement procedure.
2) Remove the oil filter (1) using the special tool.
Special tool
Maintenance and Lubrication:
1,
(a)
(A): 09915–40610 (Oil filter wrench)
(A)
0B-9
I649G1020021-03
3
I649G1020022-01
1
I649G1020023-02