Rear Brake Caliper Disassembly And Assembly - Suzuki 2005 GSF1200 Service Manual

4C-4 Rear Brakes:
4) Pivot the caliper up and remove the caliper from the
caliper bracket.
Installation
Install the brake caliper in the reverse order of removal.
Pay attention to the following points:
• Set the caliper to the caliper bracket.
• Install the brake pads and tighten the caliper mounting
bolt. Refer to "Rear Brake Pad Replacement: ".
• Tighten the sliding pin (1) to the specified torque.
Tightening torque
Rear brake caliper sliding pin (a): 27 N·m (2.7 kgf-
m, 19.5 lb-ft)
• After setting the brake hose union to the stopper,
tighten the union bolt (2) to the specified torque.
CAUTION
!
The seal washers should be replaced with the
new ones to prevent fluid leakage.
Tightening torque
Brake hose union bolt (b): 23 N·m (2.3 kgf-m, 16.5
lb-ft)
I649G1430010-01
• Bleed air from the brake system after installing the
caliper. Refer to "Brake System Inspection: in Section
0B".
• Check the brake fluid leakage and brake operation.
WARNING
!
Brake fluid, if it leaks, will interfere with safe
running and discolor painted surfaces.
I649G1430011-01
Check the brake hose and hose joints for
cracks and fluid leakage.

Rear Brake Caliper Disassembly and Assembly

Refer to "Rear Brake Caliper Removal and Installation: ".
Disassembly
1) Remove the pad spring (1) and rubber boot (2).
2,
(b)
1,
(a)
I649G1430012-01
B649G14306015
2
1
I649G1430013-01