Generator Parts Inspection - Suzuki 2005 GSF1200 Service Manual

• Tighten the generator driven gear nut to the specified
torque.
Tightening torque
Generator driven gear nut (c): 55 N·m (5.5 kgf-m,
4.0 lb-ft)
NOTE
After tightening the generator driven gear nut
to the specified torque, stake the nut using a
punch.
(c)

Generator Parts Inspection

Refer to "Generator Disassembly and Assembly: ".
Rotor Bearing
Inspect the rotor bearings for abnormal noise. Also,
rotate the rotor bearings by hand and make sure that
they rotate smoothly.
If there is unusual, replace the bearing with a new one.
Play
7
(b)
7
(b)
I649G11A0028-01
B649G11A06012
Play
I649G11A0029-01
Generator Driven Gear Damper
Inspect the generator driven gear dampers for wear and
damage. If any defects are found, replace the generator
driven gear dampers as a set.
NOTE
When installing the generator driven gear
dampers, apply SUZUKI MOLY PASTE to the
damper surface.
: Moly paste 99000–25140 (SUZUKI Moly paste
or equivalent)
Stater Coil Continuity Check
Measure the continuity between the lead wires of the
stator coil using a tester.
If there is no continuity, replace the stator.
Also, check that the stator is properly insulated.
Special tool
(A): 09900–25008 (Multi-circuit tester set)
Tester knob indication
Continuity test ( )
P
3
P
4
Charging System: 1J-10
I649G11A0030-01
P
2
P
1
I649G11A0031-01
P
1
]
P
2
]
]
P
3
P
4
I649G11A0032-01