Oil Jet / Oil Gallery Jet Inspection; Oil Pump Removal And Installation - Suzuki SFV650 Service Manual

Oil Jet / Oil Gallery Jet Inspection

Refer to "Oil Jet Removal and Installation (Page 1E-9)".
Oil Jet
Make sure that the oil jets are not clogged. If they are
clogged, clean their oil passage using a wire of the
proper size and compressed air.
1
1. Piston cooling oil jet
2. Oil gallery jet (for cylinder)
3. Oil gallery jet (for transmission)
4. Oil jet (for tensioner adjuster)

Oil Pump Removal and Installation

NOTE
Do not drop the each parts into the
crankcase.
Removal
1) Drain engine oil. Refer to "Engine Oil and Filter
Replacement in Section 0B (Page 0B-10)".
2) Remove the clutch. Refer to "Clutch Removal in
Section 5C (Page 5C-7)".
3) Remove the snap ring (1) and oil pump driven gear
(2).
Special tool
: 09900–06107 (Snap ring pliers)
2
B944H11506010
3
4
2
I944H1150030-01
B944H11506011
1
I944H1150031-01
Engine Lubrication System:
4) Remove the pin (3) and washer (4).
4
5) Remove the oil pump (5) by removing the oil pump
mounting bolts (6).
5
6
Installation
Installation in the reverse order of removal. Pay attention
to the following points:
• Tighten the oil pump mounting bolts (1).
• Install the washer (2) and pin (3).
NOTE
Be careful not to drop the washer (1) and pin
(2) into the crankcase.
1
1E-12
3
I944H1150032-02
6
I944H1150033-02
2
1
3
I944H1150034-02