Suzuki 2005 GSF1200 Service Manual page 117

Oil Pump
• Install the O-rings ((1) and (2)) and dowel pins (3) in
the correct position as shown.
CAUTION
!
Replace the O-rings with new ones to prevent
oil leakage.
1
• Apply a small quantity of THREAD LOCK "1342" to
the oil pump mounting bolts.
: Thread lock cement 99000–32050 (Thread
Lock Cement 1342 or equivalent)
• Install the oil pump (4) into the lower crankcase with
the three bolts and then tighten them to the specified
torque.
Tightening torque
Oil pump mounting bolt: 10 N·m (1.0 kgf-m, 7.0
lb-ft)
• Install the oil jets (for the transmission) (5).
NOTE
Apply engine oil to the O-rings. Make sure
that the oil jets in the lower crankcase are not
clogged.
5
2
3
I649G1140141-01
5
4
I649G1140142-01
Transmission
• Install the gearshift cam stopper bolt (1).
NOTE
Before installing the gearshift cam stopper
bolt (1), apply a small quantity of THREAD
LOCK "1342" to it.
: Thread lock cement 99000–32050 (Thread
Lock Cement 1342 or equivalent)
NOTE
When installing the gearshift cam stopper
plate (2), align the pin groove "A" with the pin
"B" as shown.
"B"
Engine Mechanical: 1D-49
1
I649G1140143-03
"A"
2
I649G1140144-02