CKP Sensor / Oil Pressure Switch
1) Remove the CKP sensor component parts (1). Refer
to "CKP Sensor Removal and Installation: in Section
1H".
2) Disconnect the oil pressure switch lead wire and
remove the oil pressure switch (2). Refer to "Oil
Pressure Switch Removal and Installation: in
Section 1E".
1
2
Clutch
1) Remove the clutch component parts (1). Refer to
"Clutch Removal: in Section 5C".
1
2) Draw out the clutch push rod (2).
2
Gearshift
1) Remove the snap ring and washer from the gearshift
shaft.
Special tool
2) Draw out the gearshift shaft (1), and then remove the
gearshift cam driven gear (2).
NOTE
I649G1140096-02
When removing the gearshift cam driven
gear, do not lose the gearshifting pawl (3), pin
(4) and spring (5).
2
I649G1140098-02
Oil Pump Driven Gear
1) Remove the snap ring (1).
Special tool
I649G1140099-02
Engine Mechanical:
: 09900–06107 (Snap ring pliers)
3
1
: 09900–06107 (Snap ring pliers)
1
1D-43
I649G1140109-01
4
5
2
5
4
3
I649G1140110-02
I649G1140111-01