1G-30 Fuel System:
Service Data
Carburetor
Item
Carburetor type
Bore size
I.D. No.
Idle r/min.
Float height
Main jet (M.J.)
Jet needle (J.N.)
Needle jet (N.J.)
Throttle valve (Th. V.)
Pilot jet (P.J.)
Pilot screw (P.S.)
Throttle cable play (Pulling cable)
Starter (enricher) plunger cable play
Oil
Item
Fuel type
Fuel tank capacity
Brake fluid type
Tightening Torque Specifications
Fastening part
Fuel valve mounting bolt
Fuel level gauge mounting bolt
Carburetor heater
Carburetor set shaft
TP sensor screw
NOTE
The specified tightening torque is also described in the following.
"Fuel Tank Construction: "
"Carburetor Components: "
Reference:
For the tightening torque of fastener not specified in this section, refer to "Tightening Torque Specifications: in Section
0C".
Specifications
E-02, 19, 24
MIKUNI BSR36
36 mm (1.42 in)
49G0
1 200 ± 100 r/min
13.0 ± 1.0 mm (0.51 ± 0.04 in)
#100
5C70 – 3rd
P-0M
#100
#15
PRE-SET (3-1/2 turns back)
2.0 – 4.0 mm (0.08 – 0.16 in)
0.5 – 1.0 mm (0.02 – 0.04 in)
Specification
Use only unleaded gasoline of at least 87 pump octane or 91
octane (R/2 + M/2) or higher rated by the research method.
Gasoline containing MTBE (Methyl Tertiary Butyl Ether), less
than 10% ethanol, or less than 5% methanol with
appropriate cosolvents and corrosion inhibitor is permissible.
Gasoline used should be graded 91 octane or higher. An
unleaded gasoline type is recommended.
Including reserve
Reserve only
Tightening torque
N⋅m
4.4
10
3.0
5.0
2.0
Specification
20 L (5.3/4.4 US/lmp gal)
4.4 L (1.2/1.0 US/lmp gal)
DOT 4
kgf-m
lb-ft
0.44
3.2
1.0
7.0
0.3
2.0
0.5
3.5
0.2
1.5
B649G11707004
E-28
←
←
49G1
1 300 ± 100 r/min
←
←
5C71
←
←
←
←
←
←
Note
E-28
The others
countries
B649G11707005
Note