9) Remove the rotor (9) from the generator end housing
(10) using a hand press "A" as shown.
"A"
10) Remove the expander ring.
11) Remove the rotor bearing (11) using the special tool.
Special tool
(B): 09913–60910 (Bearing remover)
NOTE
If there is no abnormal condition the rotor
bearing removal (11) is not necessary.
(B)
11
12) Remove the bearing retainer (12).
9
10
I649G11A0017-03
11
I649G11A0018-03
12
I649G11A0019-02
13) Remove the bearing (13), washer (14) and spacer
(15).
14) Remove the oil seal (16).
16
Assembly
Reassembly is in the reverse order of disassembly.
Pay attention to the following points:
CAUTION
!
• The removed bearing(-s) and oil seal
should be replaced with new one(-s).
• Replace the O-ring with a new one.
• Apply SUZUKI SUPER GREASE "A" to the lip of the
oil seal.
: Grease 99000–25010 (SUZUKI SUPER
GREASE A or equivalent)
Charging System:
1J-8
15
14
13
I649G11A0020-02
I649G11A0021-02
I649G11A0022-01