Rear Brake Master Cylinder Components; Rear Brake Master Cylinder Assembly Removal And Installation - Suzuki 2005 GSF1200 Service Manual

4A-12 Brake Control System and Diagnosis:

Rear Brake Master Cylinder Components

1. Reservoir tank
2. Brake hose union bolt
3. Brake hose connector
Rear Brake Master Cylinder Assembly Removal
and Installation
Removal
1) Remove the right frame cover. Refer to "Exterior
Parts Removal and Installation: in Section 9D".
2) Drain brake fluid. Refer to "Brake Fluid
Replacement: ".
3) Remove the reservoir mounting bolt (1).
1
1
(a)
6
(b)
4. Master cylinder
5. Piston/Cup set
6. Push rod
B649G14106032
I649G1410030-01
2,
(a)
3
4
5
: 23 N⋅m (2.3 kgf-m, 16.5 lb-ft)
: 18 N⋅m (1.8 kgf-m, 13.0 lb-ft)
: Apply silicone grease.
4) Place a rag underneath the brake hose union bolt (2)
on the master cylinder to catch any spilt brake fluid.
5) Remove the brake hose union bolt (2) and
disconnect the brake hose.
6) Loosen the lock-nut (3).
7) Remove the master cylinder mounting bolts (4).
8) Remove the master cylinder along with the reservoir
by turning the push rod (5).
3
B649G14106031
I649G1410029-05
: Apply brake fluid.
: Do not reuse.
2
4
5
I649G1410031-01