Range Selector Assembly On The Gearbox Cover; Primary Shaft Reassembly On The Housing; Primary Shaft Shimming - MOTO GUZZI California EV Workshop Manual

A
B
C
A
D
E
F
G
H
I
L
M

PRIMARY SHAFT SHIMMING

N
mm 2
mm 2,1
mm 2,2
mm 2,4
O
P
AUSDISTANSIERUNG DER PRIMARWELLE
32
Locking plate assembly on the clutch shaft bearing
B
on the housing and on the secondary shaft cover.
Make sure that they perfectly stick to the bearing external
ring nut.
Before screwing the retaining screws, the locking plates
on the housing and cover, cover the threaded part with
"Loctite".
Seal rings assembly on the clutch shaft gearbox
C
housing and on the cover of the secondary shaft and
range selector shaft.
The clutch shaft seal ring "A" assembly on the gearbox
housing shall be carried out with the relevant punch code
14929400, see chapter 5 section B.
The secondary shaft seal ring "B" assembly on the
gearbox housing cover shall be carried out with the
D
relevant punch code 14929500, see chapter 5 section B.
The range selector shaft O-ring "C" shall be placed in the
relevant seat on the gearbox cover.

Range selector assembly on the gearbox cover

Check that the spring "D" is assembled on the range
selector as in the picture on the side, then insert the range
selector pin on the cover and screw the eccentric screw
"E" with lock nut.

Primary shaft reassembly on the housing

Before being reassembled on the housing, the primary
shaft shall be shimmed so that between the bearing on
the housing and the bearing on the cover there is a
distance of mm 167.1 ÷ 167.2.
E
Use suitable washers to obtain this measure. These
washers are supplied in 2 – 2.1 – 2.2 –2.4 mm sizes.
This washer shall be assembled between housing bearing
and thrust bearing.
Once shimmed, press the inner roller bearing race on
the shaft (on the housing side) by means of the specific
tool code 17945460.
167,1 ÷ 167,2
18,35 ÷ 18,50
AANPASSING PRIMAIRE AS
G
EARBOX