Intermediate Plate; Control Transmission; Clutch Adjustment Screw On Lever; Lever Return Spring On Gearbox - MOTO GUZZI California EV Workshop Manual

A
B
C
D
E
F
G
H
I
L
M
N
O
P
54
Also check:

Intermediate plate "4"

Check that the surfaces touching the driven plates (with
friction material) are perfectly smooth and even and that
the external teeth inside the flywheel is not damaged,
otherwise replace the plate.

Control transmission

Check that the transmission cable has no damaged wires,
otherwise replace the transmission.

Clutch adjustment screw on lever "14"

Make sure that the screw is in good condition and that
the part on the plate control outer body is not flattened,
otherwise replace it.

Lever return spring on gearbox "13"

Check that the spring is not deformed or has not lost
elasticity, otherwise replace it.
Outer body "10"
Check where the adjustment screw head works; if the
mark is very deep, replace it.
Thrust bearing "9"
Make sure that the bearing is in good condition, otherwise
replace it.
Inner body "8"
Check the surface where the thrust bearing lies, if
damaged, replace it.
Cone bearings in the clutch shaft "7"
Check that the bearings are in good condition, and are
not hardened or crushed; squeaking or oil leakages in
the clutch plate may be caused by the above-mentioned
bearings.
Push-rod "6"
Check that it is not deformed, damaged or shortened;
replace it if necessary.
Retainer on the push-rod "5"
Check that the sides working on the spring pressure plate
are not too much worn, otherwise replace them.
O-ring seal on the outer body "11"
Check that it is not damaged or that it has not lost elasticity,
otherwise replace it.
E
NGINE