MOTO GUZZI California EV Workshop Manual page 215

A
B
C
D
E
F
G
H
I
L
M
N
O
P
74
Overhaul:
Check that the swinging arm has no bent or unsoldered
parts, that the bearing seats are in good condition and
that the connection surface between the right-hand arms
and the housing has no deep scoring.
Check the wear of the bearings on the swinging arm pivot
axis on the chassis and of the bearing on the right-hand
section.
Use the proper extractor, part no. 18927250, to remove
the U-joint bearing. Use the proper extractor, part no.
12904700, to remove the swinging arm shaft bearings.
IMPORTANT
Once a bearing has been removed from its seat,
it cannot be reused.
Reassembly:
Carry out the removal procedures in reverse order. Use
the proper drift, part no. 17945260, to press the cone
bearing outer races for the support pins. Use the proper
drift, part no. 17945360, to press the bearing on the right-
hand arm.
40 N8
62 N7
40 N8
W
HEEL PARTS
- 0,003
mm
- 0,042
- 0,009
mm
- 0,039
- 0,003
mm
- 0,042