MOTO GUZZI California EV Workshop Manual page 147

A
B
C
D
E
F
G
H
I
L
M
N
O
P
6
A
R 2 (W
EMOVAL
• Place a support under the motorbike to lift the front
F
wheel from ground.
• Remove calipers as described in removal (1).
• Loosen the 2 fastening screws between the shaft and
the fork legs.
• Remove shaft "A", remove spacers "F" and then
remove the wheel.
Refer to chapter 3 of this section for wheel overhaul.
R 2
EASSEMBLY
After carrying out all necessary wheel checks, reassemble
as follows:
• Place the complete wheel between the fork legs.
• Lubricate the shank and the thread of the wheel shaft
with the suggested grease.
• Lubricate the thread in the left-hand leg.
• Place the spacers and screw in the wheel shaft.
• Tighten the 2 screws fastening shaft and leg at the
prescribed torque.
• Reassemble the brake caliper/s and tighten the
fastening screws to the prescribed torque.
• Check that the disks run freely inside the calipers and
then operate the brake lever repeatedly to bring the
calipers pistons to the normal position.
ITH SHAFT SCREWED ON THE LEG
W
HEEL PARTS
)