Oil Pump - MOTO GUZZI California EV Workshop Manual

A
B
A
C
D
E
F
G
H
I
L
M
N
O
P
14
7
9,985÷10,000 26,340÷26,390
26,250÷26,290
15,973÷16,000
16,032÷16,075
O "7"
IL PUMP
The oil pump used is a gear type pump and is driven
directly by the crankshaft through a belt.
Removal:
• Drain all the engine oil as described in chapter 2
section D;
• Remove the entire engine following the instructions
reported in chapter 2 of this section;
• Remove the alternator following the instructions
reported in chapter 7 of this section;
• Remove the timing system cover as described in
chapter 4 of this section;
• Remove the engine pinion, the timing system gearing
and the oil pump gearing, together with the timing
belt following the procedures described in chapter 4
of this section;
• Remove the belt tensioner as described in chapter 4
of this section;
• Remove the oil pump "7" by unscrewing the fastening
screws "A" fissaggio. If defects due to the pump are
found, check:
• The gearing height, which must be between mm
15,973÷16,000;
• The seat heights on the pump body, which must be
between mm 16,032÷16,075;
In the event that the above parts do not feature the above
mentioned values, it is necessary to replace them.
Refitting:
• Carry out the procedures described for disassembly
in reverse order.
21,989÷22,002
21,972÷21,993
9,990÷10,002
22,330÷22,350
10,013÷10,035
E
NGINE