MOTO GUZZI California EV Workshop Manual page 101

A
B
C
D
E
F
C
G
H
I
L
M
N
O
P
36
L
EFT
S
PECIAL
A
Draining:
•
•
•
•
If no drainer is available, the fluid can be drained by
connecting a flexible tube "C" to the draining union. The
end of this tube must be immersed in a brake fluid
container.
Unscrew the draining union by a 1/4 turn and activate the
control lever until all the fluid has been drained;
Filling:
•
•
•
•
•
B •
If no drainer is available, connect a small transparent
plastic tube to the draining union, as described for draining
the system.
Open the draining valve by a 1/4 turn and activate the
control lever until the fluid starts to come out from the
valve.
-
HAND FRONT AND REAR BRAKING SYSTEM
- S S )
PECIAL PORT
Unscrew the cover together with diaphragm from the
tank "A";
Rotate the handlebar until the tank "A" is in a horizontal
position;
Remove the rubber cover from the draining union "B"
and fit a commercially available brake drainer onto
the union;
Loosen the draining union and use the drainer to pump
until no more fluid comes out of the system;
Fill the tank with prescribed oil taken from a sealed
container;
Activate the control lever several times to fill the system
and to eliminate any air;
Connect a drainer to the draining union;
Pump using a drainer and loosen the draining union,
always checking that the level does not drop below
the minimum level;
Repeat this final procedure until there are no air
bubbles in the transparent tube connected to the
draining union;
Lock the union to the torque prescribed in the table in
chapter 4, section B.
N.B. The draining on the rear caliper must be
carried out with the disassembled caliper in
horizontal position.
S M
CHEDULED
(C EV -
ALIFORNIA
AINTENANCE