Battery Cover Assembly - MOTO GUZZI V85 TT Service Station Manual

Pre-delivery
•
Installation of the handguards begins
with the insertion of the rubber piece
(1) in the specific cylindrical lodging on
the internal side of the handguards.
•
Then, rest the anti-vibration weight (2)
in correspondence to the end of the
handlebar and on this handguard (3),
taking care to line up the inside with the
shape of the anti-vibration weight;
then, the "T" bushing (4) should be in-
serted on the handguard and the screw
(5) inserted without tightening it all the
way.
•
Then, insert the other "T" bushing from
below on the second handguard fas-
tening hole and screw in the rear view
mirror (6)
•
Then, tighten the screw (5), observing
the tightening torque indicated on the
attached chart
•
Repeat the same procedure to mount
the handguard/rear view mirror on the
opposite side
H
Tightening torque chart
Fastening handguard / anti-vibration weight to handlebar

BATTERY COVER ASSEMBLY

•
Remove the saddle, acting on the lock
positioned on the licence plate holder
and lift it from the rear part, unhooking
it from its lodgings in correspondence
to the fuel tank
•
Remove the screws (1) and extract the
battery cover (2) from the front lodg-
ings, sliding it toward the rear
PRE DE - 254
/
ANDGUARDS REAR VIEW MIRRORS KIT TIGHTENING TORQUES
Tightening torques Residual torque Nm
Nm (lbf ft)
6 Nm (4.43 lb ft) 4.8 Nm (3.54 lb ft)
V85 TT
(lbf ft)