MOTO GUZZI California EV Workshop Manual page 436

A
B
C
D
E
F
G
H
I
L
M
N
A
O
B
P
46
Reassembly of the clutch control unit in the clutch
shaft and on the gearbox housing cover
Reassemble:
• The internal body "B" on the shaft.
• The thrust bearing "C" on the internal body end.
• The external body "D" provided with the cover seal
ring "E".
• The control rod "F" in the shaft housing side.
• The lever on the cover complete with adjuster and
lock nut by means of pin and splint pins "G".
• The lever return spring in its seat on the cover "H".
H
D
E
C
B
F
Gearbox housing assembly complete with shafts and
gears on the engine
To reassemble the gearbox housing on the engine,
proceed as follows:
• Insert the gearbox housing on the stud bolts
assembled on the engine, carefully placing the clutch
internal body on the two clutch plates previously
installed.
• Screw and lock the nuts on the stud bolts and the
fastening screws of the gearbox housing on the engine.
Clutch control lever adjustment on the housing
Once assembled the gearbox housing on the engine,
move on to the clutch control lever adjustment proceeding
as follows:
• Screw or unscrew the adjuster "B" after loosening the
lock nut "A". A distance of 75 mm shall be obtained
between the gearbox cover surface and the centre of
the spherical slot where the roller has to be placed on
the transmission.
G
EARBOX
G