Crank Shaft And Connecting Rods - MOTO GUZZI California EV Workshop Manual

A
B
C
D
E
F
G
H
I
L
M
N
G
O
P
62
A
B
B
A
D
E
H
8 CRANKSHAFT AND CONNECTING
RODS
Disassembly:
• Remove the engine unit from the motorbike, following
the instructions described in chapter 2 in this section;
• Remove the heads, as described in chapter 4 in this
section;
• Remove the cylinders and pistons following the
instructions described in chapter 5 in this section;
• Remove the clutch as described in chapter 6 in this
section;
• Remove the alternator and the flywheel following the
descriptions in chapter 7 in this section;
• Remove the timing system as described in chapter 4
in this section;
• Remove the oil sump as described in chapter 3 in this
section;
C
• Unscrew screws "A" from the crankcase inner side
and remove connecting rods "B";
• Unscrew screws "D" and remove the crankshaft flange
"C" (alternator side);
• Unscrew the fastening screws "E" of the crankshaft
rear flange "F";
• Use the tool "G" (code 12 91 36 00), as illustrated in
the picture, to remove the rear flange "H";
• Remove the crankshaft from the rear side;
F
E
NGINE