MOTO GUZZI California EV Workshop Manual page 432

A
B
C
D
E
F
G
H
SPLINED DRUM SHIMMING
AUSDISTANZIERUNG DER SCHALTWALZE
DE TROMMEL MET GLEUVEN AANPASSEN
I
L
M
N
O
P
42
A
B
Assembly with Loctite 601
Einbau mit Loctite 601
Monteren met Loctite 601
mm 0,6
mm 0,8
mm 1
mm 1,2
• Adjust the gearbox control by means of the eccentric
screw "A" after unscrewing the lock nut "B" until the
gear engages smoothly.
• Try to engage the gears from 1
from 5 th to 1 st and then in neutral. If the gears engage
with difficulties, it is necessary to disassemble the
cover and to fit a suitable shim between the housing
and the drum in case of difficulties between 1
gear, and between the drum and the cover between
nd th
2 and 4 gear. Shims are supplied in the following
sizes: 0.6 – 0.8 - 1 – 1.2 mm.
Once shimmed, reassemble the cover following the
above-mentioned instructions and try to engage the
gears again. Make sure that the gears engage
properly; lock the nut on the secondary shaft with the
specific tool code 14905400 and the secondary shaft
retaining tool code 12907100.
Lock the nut, with a graver hit the nut end near the
shaft spline in order to retain the nut itself.
Carefully screw the screws that secure the cover to
the housing and remove the operating tool from the
range selector shaft.
Insert the control lever on the range selector shaft by
locking it with a screw.
• Carefully lock the pawl fastening plug.
mm 0,6
mm 0,8
mm 1
mm 1,2
G
EARBOX
st th
to 5 and shift down
st rd
and 3