Clutch And Front Brake Control; Removal Of Front Brake Lever With Master Cylinder; Removal Of Front Clutch Lever - MOTO GUZZI California EV Workshop Manual

A
B
C
B
D
E
D
F
G
H
A
I
L
M
N
O
P
2
A
C
E
B
C
E
D
1

CLUTCH AND FRONT BRAKE CONTROL

Removal of front brake lever with master cylinder:

• Drain the hydraulic system thoroughly, as described
in chapter 2, section D;
• Detach the connections "A" for the micro-switch "B"
• Unscrew the hollow screw "C" fastening the tube to
the pump;
• Remove the tube and the gaskets from the pump;
• Remove the rear-view mirror;
• Unscrew the two screws "D" which fasten the pump to
the half-handlebar using a jumper "E";
• Remove the pump together with the tank and lever;
Reassembly:
• Fit the pump onto the half-handlebar by tightening the
two fastening screws;
• Reconnect the tube to the pump by tightening the
hollow screw to the torque prescribed in the table in
chapter 4, section B;
• Connect the electric wirings to the micro-switch on
the master cylinder;
• Assemble the mirror;
• Fill the system with the prescribed hydraulic system
fluid.

Removal of front clutch lever:

• Remove the rear-view mirror;
• Move the protective cover "A" and disconnect the
CHOKE transmission "B" and the clutch "C" from their
respective lever;
• Unscrew the 2 screws "D" fixing the clutch lever
mounting to the handlebar using a U-bolt "E".
C
ONTROLS