Table of Contents
Advertisement
MAINTENANCE
TRANSMISSION OIL
3-20
OIL
LEVEL
INSPECTION
,. Start
the
engine and let
it
idle for 3 minutes.
2. Stop the engine and wait 3 minutes.
3. Support the motorcycle upright on a level sur-
face.
4. Remove the oil
filler
cap and check bolt from the
right
crankcase cover. A small amount of oil
should flow out of
the
check bolt hole.
5. If no oil flows out of
the
check bolt hole, add oil
slowly through
the
oil
filler hole
until
oil
starts
to
flow out of the check bolt hole. Install the oil
check bolt and fi
l
ler
cap.
6.
Repeat
steps 1
-
5.
7. After checking the oil level or adding
oi
l, tighten
the oil check
bolt
with a new sealing washer and
filler cap securely.
TRANSMISSION
OIL CHANGE
•
Transmission
oil should be
changed
at least
every six
races
or
15
hours
of operation to
ensure consistent performance and maximum
service life of both transmission and clutch com-
ponents
.
•
Warm-up the engine before draining the oil. This
will
ensu
re complete and rapid draining.
1.
Support the motorcycle in an upright position on
level surface.
2. Remove the
oil
filler
cap
from the right
crankcase
cover.
3.
Place an oil pan under the
engine
to
ca
tch
the oil,
then remove
the
drain bolt
and
washer.
4.
After the oil has drained
completely,
install the
drain bolt with a new sealing washer.
Tighten the
transmission oil drain bolt to
the
specified
torque.
TORQUE:
'04
- '06:
22 N 'm 12.2 kgf·m,
16
Ibf.ft)
After
'06:
16
N·m 11.6 kgf·m,
12
Ibf·ft)
I!!I
DRAIN BOLT/SEALING WASHER
Advertisement
Table of Contents
Troubleshooting
