Engine Installation - Honda 2004 CRF250X Service Manual

Note the direction of the engine hanger plates and
mounting bolts.
Temporarilv install the swing arm pivot bolt so the
chassis can be moved and stored safely.
ENGINE INSTALLATION
Install r/'le engme
bottom end first
from the lefr side of
the ff8me
Install the engine in the frame.
Apply thin coat of grease to the swingarm pivot bolt
Sliding surface.
Inslall the swingarm pivot bolt, washer and nul.
Carefully align the bolt holes in the frame and
engine.
Install the engine mounting bolts, washers and
nuts .
.. Route the wires and cables properly (page 1-23),
• Do not tighten the 5wingarm pivot nut and
engi ne mounting nuts yet .
.. Each engine hanger plates have an identification
mark, "l " is for the left side and "W is for right
side .
.. Install the hanger plates with the identification
mark facing out.
Install the washer, engine hanger plates, bolts and
nuts.
Tighten the engine mounting nuts, engine hanger
plate nuts and swingarm pivot nut t o the specified
torque .
TORQUE:
Swingarm pivot nut: 88 N 'm (g.O kgf·m, 65Ibf.ft)
Engine hanger plate nut
(engine side); 54 N 'm (5.5 kgf·m , 40 Ibf.ft)
(frame side):
'04:
After '04:
Engine mounting nut
(front);
(lower):
26 N ·m (2.7 kgf·m , 20 Ibf.ft)
34 N·m (3.5 kgf·m , 25 Ibf·ft)
54 N 'm (5.5 kgf·m , 40 Ibf·ft)
64 N 'm (6.5 kgf·m , 47Ibf·ft)
ENGINE REMOVALIINSTALLA TION
o
0
7-7