Honda 2004 CRF250X Service Manual page 116

FUEL SYSTEM
5-20
Install and tigh ten the slow air jet to the specified
torque.
TORQUE: 1,0 N 'm
10.1
kgf·m, 0.7 Ibf.ftl
Install the O-ring, washer, spring and pilot screw.
Perform pilot screw adjustment if a new pilot screw
is installed (page 5-27) .
• Install the pilot screw and return it to its original
position as noted during removal.
Install the slow jet. staner jet, baffle plate, needle jet
and main jet.
TORQUE:
Stow let: 1.5 N'm (0.15 kgf·m, 1.1Ibf.tt)
Starter jet: 1.5 N'm (0.15 kgf·m, 1.1 Ibf.ft)
Needle jet : 2.0 N'm
to.2
kgf·m, 1.4 Ibf.ft)
M ain jet: 1.5 N'm (0.15 kgf-m , 1.1 Ibf·ft )
Install the float valve, float and float pin.
Check the float level after checking the float valve
and float.
Set the float level gauge so
it
is perpendicular to the
float chamber face and in-line with the main jet_
Set the carburetor so the float valve just contacts
the float arm lip. Make sure the float valve tip is
securely in contact with the valve seat .
Make sure the float is level with the ftoat level
gauge.
TOOL:
Carburetor float level gauge 07401 -0010000
FLOAT LEVEl: 8.0 mm (0.31 in)
If the float level is out of specification. adjust it by
bending the lip.