Front Visor Removal/Installation; Sub-Frame Removal - Honda 2004 CRF250X Service Manual

FRAME/BODY PANELS/EXHAUST SYSTEM
FRONT VISOR
REMOVAL/ INSTALLATION
Remove the bolts and front visor.
Remove the headlight 2P connector from clamp.
Disconnect the headlight 2P connector.
Connect the headlight 2P connector.
Clamp the headlight 2P connector securely.
Install the front viser by aligning its holes with the
tabs on the steering stem.
Install and tighten the bolts securely.
SUB-FRAME
REMOVAL
Remove the following:
- Radiator reserve tank (page 6-9)
- Battery (page 16-6)
- Air cleaner housing (page 5-7)
Remove the wire band and main relay ('04, '05 only)
from sub-frame.
Remove the siphon and reserve tank overflow
hoses from the rear fender.
Slide the rubber boot off, disconnect the taillight 2P
connector ('04, '05) or wire connectors (afte r '05).
Remove the wire band and ICM from rear fender.
FRONT VISOR
'/
2P CONNECTOR HOLES
e)
MAIN RELAY
r04, '05)
2P CONNECTOR OR
~
. . .
W IRE CONNECTORS
2-5