Accelerator Pump/Float/Jet - Honda 2004 CRF250X Service Manual

Check the valve for damage or stepped wear.
'04 - '06.
Remove the torx screw and throttle position sensor.
After '06:
Remove the bolt and thronle position sensor.
VVhen removmg
tile
throttle position
sensor, mark fhe
sensor positIOn
ensure that it
reinstalled in the
oflgma/local/on.
• The throttle position sensor is factory pre-set an d
no adjustment is necessary unless the throttle
position sensor is replaced.
• For sensor inspection (page 17·9).
• For sensor replacement (page 5·26).
ACCELERATOR PUMP/FLOAT/JETS
Remove the screws and accelerator pump cover.
NOTE:
• The accelerator pump cover is under spring pres-
sure.
• Do not lose the screws and O-ring.
Remove the spring, diaphragm, D-ring and O-ring.
FUEL SYSTEM
VALVE
'04 - '06 shown:
THAOTILE pn<IITII( IN SENSOR
SCREWS
O-RING
DIAPHRAGM
5-15