Engine Idle Speed; Transmission Oil Level Inspection - Honda 2010 CRF250R Service Manual

MAINTENANCE
ENGINE IDLE SPEED
Inspect and adjust the idle speed after all other
engine maintenance items have been performed
and are within specifications.
Before inspection, check the following ilems.
- No DTG and MIL blinking
- Spark plug condition (page 3-10)
- Air cleaner condition (page 3-8)
The engine must be warm for accurate idle speed
inspection.
Use a tachometer with graduations of 50 rpm or
smaller thai will accurately indicate a 50 rpm
change.
Start the engine and warm
it
up to coolant temperature
aooe
(176°F) .
SlOp the engine and connect a tachometer according to
Lo. _ _ _ _ _ ~
the tachometer manufacturer's operating instructions.
Start the engine and let
it
idle. Turn Ihe fast idle knob to
obtain the specified idle speed.
IDLE SPEED :2,OOO
±
100
rpm
TRANSMISSION OIL
3·16
OIL LEVEL INSPECTION
1. Start the engine and let it idle for 3 minutes.
2. Stop the engine and wait 3 minutes.
3. Support the motorcycle upright on a level surface.
4. Remove the oil filler cap. Remove the transmission
oil check bolt and sealing washer from the right
crankcase cover. A small amount of oil should flow
out of the check boll hole.
5. If no oil flows out of the check bolt hole, add
recommended transmission oil (page 3-17) slowly
through the oil filler hole until oil starts to flow out of
the check bolt hole. Install and tighten the
transmission oil check bolt and filler cap.
6. Repeat steps 1 - 5.
After checking the oil level or adding transmission
oil , tighten the transmission oil check bolt to the
speCified torque with a new sealing washer.
TORQUE : 12 N'm (1.2 kgf'm, 9 IbUt)
Check that the O-ring is in good condition. replace it if . . - - - - - - . . . ,
necessary.
Install the oil filler cap.