Honda 2004 CRF250X Service Manual page 329

Press
rile
needle
bearmg into the
shod: arm with rhe
marked side facing
OUI.
Pack new needle bearings with mUlti-purpose
grease.
Press new needle bearings into the frame side pivot
with the special tools and a hydraulic press so that
the needle bearing surface is 4.4 - 4.7 mm (0.17-
0.19 in) below the end of the shock arm surface.
TOOLS:
Driver
Attachment, 24 x 26 rnm
Pilot,20m m
INSTALLATION
07749-0010000
07746-0010700
07746-0040500
Apply mUlti-purpose grease NLGI No.2 (molybde-
num disulfide additive) to the shock arm, dust seal
lips, collars and bearings .
• Make sure the needle bearing rollers are in posi-
tion before installing.
Number of needle rollers:
Shock link side: 32
Swingarm side: 32
Shock absorber side: 27
Install the dust seals and washers (shock link side).
Install the dust seals to the shock arm (swinga rm
side).
Install the pivot collar, side collars and dust seals
(shock absorber side).
Install the pivot collars and side collars to the shock
arm (swing arm side, shock link side).
Apply multi-purpose grease NLGt No.2 (molybde-
num disulfide additive) to the dust seal l ips, collars
and bearings.
Install the dust seats, pivot collar and side colla rs.
• Make sure the needle bearing rollers are in posi-
tion before installing.
Number of needle rollers:
Number of needle rollers: 32
REAR WHEEL/SUSPENSION
4.4 - 4.7
mm
~
(O.17-0.19in)
---
I .
"
,
~
lIiiiIII'
NEEDLE
.~ BEARINGS
•
- - . , SIDE COLLARS
DUST SEALS
• -Vii@.
WASHERS
......
PIVOT COLLAR
• ..un;..
SIDE COLLARS
\' 4 i
)
-Vii@.
SIDE COLLAR
. I
J
tJ.
• .v;m.,
PIVOT COLLAR
14-33