Honda 2004 CRF250X Service Manual page 115

Afte r '06:
THROTTLE VALVE
MAINTENANCE COVER
TOP COVER
O-RING~
JET NEEDLE
NEEDLE HOLDER
SPAING~
• J
SPRING
SEAT~ ""'"
/ e,
PUSH ROD
NEEDLE CLIP STARTER JET
NEEDLE JET
MAIN JET
SLOW JET
Install the throttle
Install the throttle position sensor by aligning the
positron sensor to
tabs of the throttle position sensor with the flat side
Its
ongmal posmon
of the shaft as shown.
as marked dUring
removal
'04 - '06
Apply locking agent to the !orx screw threads.
Tighten the tooe screw to the specified torque.
TORQUE: 3.9 N·m (0.4 kgf·m , 2.9
IbUt)
Ahar '06.
Apply locking agent to a new boll threads.
Tighten the bolt to the specified torque.
TORQUE: 3.9 N·m (0.4 kgf·m. 2.9
IbUt)
• The throttle position sensor is factory pre-set and
no adjustment is necessary unless the throttle
position sensor is replaced .
• For sensor inspection. refer to page 17-9.
• For sensor replacement, refer to page 5-26.
FUEL SYSTEM
THROTTLE THROTTLE POSITION SENSOR
VAL PLATE
~
W~:R:~----.!!'----_
FLOAT VALVE
FLOAT
THROTTLE
SCREW
ACCelERATOR PUMP COVER
THROTTLE POSITION
5-19