Honda 2004 CRF250X Service Manual page 289

FRONT WHEEL/SUSPENSION/STEERING
If the handlebar grips are removed, apply Honda
Bond A or Pro Honda Hand Grip Cement
(U.S.A
only) to the inside of the grip and to the clean su r-
faces of the right of the throttle pipe and left sides of
the handlebar.
AllowlheadhesJV(?
Wait 3 - 5 minutes and install the grip.
to dry for
Rotate the grips for even application of the adhe-
approximately
1
sive.
hour before using.
Align the
"6~
mark on the left grip with the paint
;::=================~
mark on the handlebar. PAINT MARK
Align the mark on the right grip with the edge of the
throttle grip end.
Align the starter switch housing as shown.
Install and tighten the screws to the specified
torque.
TORQUE: 0.7 N'm (0.07 kgf·m, 0.5 Ibf·ft)
Install the wire bands.
Position the brake master cylinder on the handlebar.
Install the master cylinder holder with the "UP"
mark facing up and align the end of the holder with
the paint mark on the handlebar.
Tighten the upper master cylinder holder bolt first,
then tighten the lower bolt.
TORQUE: 9.8 N 'm 11.0 kgf ·m , 7Ibf.ft)
" /' 0 :. "
MARK
INDEX LINE
13-35