CLUTCH/STARTER CLUTCH/KICK STARTER/GEARSHIFT LINKAGE (After '05)
Remove the reduction gear shaft and reduction gear
B.
Temporarily install the clutch outer guide, needle
bearing and clutch outer onto the mainshaft.
Install the special tool between the primary drive
and driven gears as shown, and loosen the primary
drive gear bolt.
TOOL:
Gear holder, M2.5
07724-0010100 or
07724-001A100
(U.S.A. only)
Remove the clutch outer, needle bearing and clutch
outer guide.
Remove the primary drive gear bolt, washer and
gear.
Remove the starter clutch assembly.
DISASSEMBLY/INSPECTION
Check that the starter driven gear turns counter-
clockwise smoothly and does not turn clockwise.
Remove the driven gear and needle bearing from
starter clutch outer while turning the driven gear
counterclockwise.
STARTER CLUTCH ASSEMBLY
DRIVEN GEAR
14-16