Crankshaft Removal - Honda TRX450R Service Manual

CRANKCASE/TRANSMISSION/CRANKSHAFT/BALANCER ('04 - '05)
Apply molybdenum oil solution to the claws and
guide pins of the center and right shift forks.
Install the center shift fork into the M3 gear shifter
groove with the identification mark facing up.
Install the right shift fork into the C5 gear shifter
groove with the identification mark facing down.
Apply molybdenum oil solution to the shift fork
shafts and install them through the shift forks and
into the left crankcase.
Apply oil to the shift drum guide grooves and install
it into the left crankcase.
Install the shift fork guide pins into the shift drum
guide grooves.
Assemble the crankcase halves (page 15-25).
CRANKSHAFT
REMOVAL
Separate the crankcase halves and remove the oil
pump (page 15-11).
Remove the transmission (page 15-13).
Remove the crankshaft from the left crankcase
using a hydraulic press while holding it.
CRANKSHAFT
Remove the oil seal from the left crankcase.
Drive the crankshaft bearing out of the left crank-
case.
Remove the left crankshaft bearing using the special
tool if it comes out with the crankshaft. Discard the
bearing.
TOOL:
Universal bearing puller
07631-0010000 or
equivalent commercially
available in U.S.A.
UNIVERSAL BEARING PULLER
15-18