Honda TRX450R Service Manual page 353

FRONT WHEEL/SUSPENSION/STEERING
Install the handlebar switch onto the handlebar and
holder, and tighten the upper screw first, then
tighten the lower screw.
TORQUE: 2 N m (0.2 kgf-m, 1.4 Ibf-ft)
, HANDLEBAR SWITCH
Align the edge of Install the clutch lever bracket and holder with the
the clutch lever "UP" mark facing up. Tighten the upper bolt first,
bracket with the then tighten the lower bolt.
punch mark on the
handlebar.
PUNCH MARK * CLUTCH LEVER BRACKET
Align the edge of
the master cylinder
with the punch
mark on the
handlebar.
Install the front brake master cylinder and holder
with the "UP" mark facing up. Tighten the upper bolt
first, then tighten the lower bolt.
I "UP" MARK H ^ B B BOLTS
^ i ^ M B I I H l II III
PUNCH MARK HOLDER "UP" MARK
Align the lug on the
throttle housing
with the mating line
of the master
cylinder.
Install the throttle housing and holder against the
master cylinder. Tighten the front screw first, then
tighten the rear screw.
SCREWS
17-8