Steering Shaft Installation - Honda TRX450R Service Manual

FRONT WHEEL/SUSPENSION/STEERING
Apply grease to new dust seal lips and install them
into the frame.
INSTALLATION
NOTE:
• Route the wires, hose and cables properly (page
1-24).
'04 - '05: Install the steering shaft in the frame through the air i
A
,
D
^ , ,
lni
r-
D
i IDDCO
Be careful not to guide rubber. I AIR GUIDE RUBBER
damage the air
guide rubber.
After '05: Install the steering shaft in the frame.
Apply grease to the steering shaft bushing inner
surface.
NOTE:
• Use Shell Alvania EP-LF-2 or equivalent for steer-
ing shaft bushing.
Install the bushing onto the steering shaft with the
"UP" mark facing up.
Install the steering shaft end into the steering shaft
bearing.
Install the steering shaft holder and tighten the two
bolts alternately.
TORQUE: 32 N-m (3.3 kgf-m, 24 Ibf ft)
STEERING SHAFT HOLDER
17-28