Honda TRX450R Service Manual page 427

HYDRAULIC BRAKE
The parking brake Apply silicone grease to the parking brake shaft slid-
shaft has left-hand ing surface.
threads. Position the shaft so that the punch mark is within
the reference marks on the base, and thread it.
Screw the shaft in fully and make sure that the
punch mark is within the reference marks.
BASE
Install a new boot into the parking brake base and
shaft grooves properly.
Install a new O-ring into the parking brake base.
Install the base onto the caliper body and tighten
the two bolts.
TORQUE: 23 N m (2.3 kgf m, 17 Ibf-ft)
Apply grease to the parking brake cable end.
Install the cable into the cable holder and connect it
to the brake arm.
Turn the parking brake shaft clockwise approxi-
mately 90° from fully seated position and install the
brake arm on to the shaft by aligning the punch
marks.
19-27